Abstract

AbstractSuperconducting Tl-based films were prepared on a LaAlO3 single crystal substrate. Spray pyrolysis of Ba, Ca and Cu nitrate solutions was used for deposition of the precursor films. They were subsequently ex-situ thallinated in flowing oxygen (open system). While the superconducting Tl-2212 phase formed at an annealing temperature of 880°C, thallination at 900°C led to the formation of a Tl-2223 /Tl-2212 mixture. The amount of Tl-2223 increased with prolonged thallination, whereas the Tl-2212 phase progressively disappeared. Films prepared in such a manner were c-oriented and contained only low amounts of non-superconducting impurities. The resulting samples were characterized by XRD and SEM and their T C values were determined by resistive four-point measurements. They showed critical temperatures in the range of T ON = 125–135 K, T C0 = 91–93 K. Differences between the composition and properties of the obtained films and those thallinated in closed systems under 50 kPa of oxygen are discussed in this paper. Results show that the Tl-2212 → Tl-2223 transformation proceeds at a slower rate under flowing oxygen than in a closed system.

Full Text
Paper version not known

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.