Titration of the phase transition of phosphatidylserine bilayer membranes. Effects of pH, surface electrostatics, ion binding, and head-group hydration.

Abstract

The dependence of the gel-to-fluid phase transition temperature of dimyristoyl- and dipalmitoylphosphatidylserine bilayers on pH, NaCl concentration, and degree of hydration has been studied with differential scanning calorimetry and with spin-labels. On protonation of the carboxyl group (pK2app = 5.5), the transition temperature increases from 36 to 44 degrees C in the fully hydrated state of dimyristoylphosphatidylserine (from 54 to 62 degrees C for dipalmitoylphosphatidylserine), at ionic strength J = 0.1. In addition, at least two less hydrated states, differing progressively by 1 H2O/PS, are observed at low pH with transition temperatures of 48 and 52 degrees C for dimyristoyl- and 65 and 68.5 degrees C for dipalmitoylphosphatidylserine. On deprotonation of the amino group (pK3app = 11.55) the transition temperature decreases to approximately 15 degrees C for dimyristoyl- and 32 degrees C for dipalmitoylphosphatidylserine, and a pretransition is observed at approximately 6 degrees C (dimyristoylphosphatidylserine) and 21.5 degrees C (dipalmitoylphosphatidylserine), at J = 0.1. No titration of the transition is observed for the fully hydrated phosphate group down to pH less than or equal to 0.5, but it affinity for water binding decreases steeply at pH greater than or equal to 2.6. Increasing the NaCl concentration from 0.1 to 2.0 M increases the transition temperature of dimyristoyphosphatidylserine by approximately 8 degrees C at pH 7, by approximately 5 degrees at pH 13, and by approximately 0 degrees C at pH 1. These increases are attributed to the screening of the electrostatic titration-induced shifts in transition temperature. On a further increase of the NaCl concentration to 5.5 M, the transition temperature increases by an additional 9 degree C at pH 7, 13 degree C at pH 13, approximately 7 degree C in the fully hydrated state at pH 1, and approximately 4 and approximately 0 degree C in the two less hydrated states. These shifts are attributed to displacement of water of hydration by ion binding. From the salt dependence it is deduced that the transition temperature shift at the carboxyl titration can be accounted for completely by the surface charge and change in hydration of approximately 1 H2O/lipid, whereas that of the amino group titration arises mostly from other sources, probably hydrogen bonding. The shifts in pK (delta pK2 = 2.85, delta pK3 = 1.56) are consistent with a reduced polarity in the head-group region, corresponding to an effective dielectric constant epsilon approximately or equal to 30, together with surface potentials of psi congruent to -100 and -150 mV at the carboxyl and amino group pKs, respectively. The transition temperature of dimyristoylphosphatidylserine-water mixtures decreases by approximately 4 degree C each water/lipid molecule added, reaching a limiting value at a water content of approximately 9-10 H2O/lipid molecule.