Abstract
AbstractThe objective of this research is to obtain uniform vacuum-deposition triclinic phase II crystal of titanyl phthalocyanine (α-TiOPc) films from various TiOPc crystal forms. The crystal structure and morphology of vacuum-deposited TiOPc films can be manipulated by deposition rate and substrate temperature. Crystal structure was determined by X-ray diffraction (XRD). Thin film morphology was analyzed by scanning electron microscope (SEM). Highly ordered α-TiOPc film with an edge-on molecular orientation was deposited on octadecyltrichlorosilane (OTS) treated Si/SiO2 surface. All TiOPc crystal forms, such as amorphous, α and γ phases, provided the triclinic phase II crystal of TiOPc. The full width at half maximum (FWHM) of the peak at 7.5 degree in XRD spectra was 0.23, 0.27 and 0.29 for γ, α and amorphous powder when substrate temperature maintained at 180°C, respectively. The FWHM of the 7.5 degree peak can be achieved 0.22 deposited from all crystal forms at elevated temperature higher than 220°C. The α-TiOPc deposition film exhibited an excellent p-type semiconducting behavior in air with dense packing structure due to the close π–π molecular packing. The devices, field-effect mobility range from 0.02 to 0.26 cm2/V s depending on various process parameters. The on/off current ratio (Ion/Ioff) is over 105. The TiOPc OTFTs will be applied as multi-parameter gas sensor in the near future.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.