Abstract
Although there have been great advances in the development of cutting tool materials which have significantly improved the machinability of a large number of metallic materials, including cast irons, steels and some high temperature alloys such as nickel-based alloys, no equivalent development has been made for cutting titanium alloys due primarily to their peculiar characteristics. This paper reviews the main problems associated with the machining of titanium as well as tool wear and the mechanisms responsible for tool failure. It was found that the straight tungsten carbide (WC/Co) cutting tools continue to maintain their superiority in almost all machining processes of titanium alloys, whilst CVD coated carbides and ceramics have not replaced cemented carbides due to their reactivity with titanium and their relatively low fracture toughness as well as the poor thermal conductivity of most ceramics. This paper also discusses special machining methods, such as rotary cutting and the use of ledge tools, which have shown some success in the machining of titanium alloys.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.