Abstract
Event Abstract Back to Event Tissue-engineered skeletal muscle with collagen sponge scaffold having contractile properties Shunya Takagi1, Tomohiro Nakamura1 and Toshia Fujisato1 1 Osaka Institute of Technology, Department of Biomedical Engineering, Japan Introduction: A tissue-engineered skeletal muscle is a promising strategy for the reconstruction of skeletal muscle loss caused by tumour ablations and by accidental injury. In the process of skeletal muscle regeneration, myoblasts fuse each other to form multinucleated myotubes, and then the myotubes mature to myofiber in vivo. The primary function of skeletal muscle is to generate force. We have already prepared the tissue-engineered skeletal muscle of three-dimensional structure having diameter of about 0.5 mm and length of 12 mm by the collagen gel cell culture. However, it is still a big challenge to construct a matured muscle tissue in vitro having applicable mass to tissue transplantation. As tissue constructs increase in scale, their size is limited by poor nutrient supply. The current major issue is a lack of angio architecture in the tissue-engineered constructs. In this study, a collagen scaffold having uniaxial porous structure was reported for the large-scaled and has function native-like contractile properties by electrical stimulations for tissue-engineered skeletal muscle. Materials and Methods : The polytetrafluorethylene tube was filled with Type I collagen gel solution. It was placed vertically and frozen by gradual immersion into liquid nitrogen from its bottom to top. The frozen collagen gel solution was then dried in a vacuum oven. The obtained sponge scaffold was subjected to the SEM observation. The C2C12 established myoblasts were seeded into the collagen sponge scaffold. The construct was cultured for 2 days in DMEM containing fetal bovine serum and then the medium was changed to DMEM containing horse serum to enhance differentiation of the cells to the myotubes. The contractile force of tissue-engineered skeletal muscle caused by electric stimulation was measured after cultures. Then the construct was observed histologically by HE staining. Results and Discussion: The obtained collagen sponge was shown to have unidirectional porous structure. This structure may be created by ice crystals formed vertically in the collagen solution by gradual freezing by liquid nitrogen. The C2C12 cells were dispersed throughout the structure of the collagen sponge. However tissue-engineered skeletal muscle observed C2C12 cells gradually becomes one line. Tissue-engineered skeletal muscle the reaction was in response to the twitch and tetanus stimulation applied. Fig.1 Histological evaluation of collagen sponge scaffold. (A) The SEM image of collagen sponge scaffold. Bar = 200 µm. (B) The HE staining of cultured tissue-engineered skeletal muscle. Bar = 100 µm. Conclusions: From these results, the collagen sponge having unidirectional porous structure may be useful for giving large mass tissue engineered constructs. Collagen sponge has native-like contractile properties by electrical stimulations. Keywords: Cell Differentiation, Tissue Engineering, in vivo Conference: 10th World Biomaterials Congress, Montréal, Canada, 17 May - 22 May, 2016. Presentation Type: Poster Topic: Biomaterials in constructing tissue substitutes Citation: Takagi S, Nakamura T and Fujisato T (2016). Tissue-engineered skeletal muscle with collagen sponge scaffold having contractile properties. Front. Bioeng. Biotechnol. Conference Abstract: 10th World Biomaterials Congress. doi: 10.3389/conf.FBIOE.2016.01.00651 Copyright: The abstracts in this collection have not been subject to any Frontiers peer review or checks, and are not endorsed by Frontiers. They are made available through the Frontiers publishing platform as a service to conference organizers and presenters. The copyright in the individual abstracts is owned by the author of each abstract or his/her employer unless otherwise stated. Each abstract, as well as the collection of abstracts, are published under a Creative Commons CC-BY 4.0 (attribution) licence (https://creativecommons.org/licenses/by/4.0/) and may thus be reproduced, translated, adapted and be the subject of derivative works provided the authors and Frontiers are attributed. For Frontiers’ terms and conditions please see https://www.frontiersin.org/legal/terms-and-conditions. Received: 27 Mar 2016; Published Online: 30 Mar 2016. Login Required This action requires you to be registered with Frontiers and logged in. To register or login click here. Abstract Info Abstract The Authors in Frontiers Shunya Takagi Tomohiro Nakamura Toshia Fujisato Google Shunya Takagi Tomohiro Nakamura Toshia Fujisato Google Scholar Shunya Takagi Tomohiro Nakamura Toshia Fujisato PubMed Shunya Takagi Tomohiro Nakamura Toshia Fujisato Related Article in Frontiers Google Scholar PubMed Abstract Close Back to top Javascript is disabled. Please enable Javascript in your browser settings in order to see all the content on this page.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.