Abstract
The reduction gear's friction strongly affects the dynamic characteristics of a one-link flexible robot arm. Experiments of open loop response by motor torque were performed in two cases of large and small values of the reduction gear's friction, and compared with simulation. The reduction gear's friction has both viscous and Coulomb aspects and can be approximately treated as an equivalent viscous friction. However, tip position control was very difficult in the case of large friction with an equivalent viscous friction. Experiments indicated that tip position feedback control was possible by using a dither signal and linearizing the non-linear friction.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
