Timing Recovery in Digital Subscriber Loops Using Baud-Rate Sampling

Abstract

Sampled-data techniques are the most practical means of obtaining the necessary signal processing functions for timing recovery in the VLSI implementation of a digital subscriber loop transceiver. The sampled-data timing recovery techniques described in this paper are applicable to both echo cancellation and time-compression multiplexing systems. Timing recovery using baud-rate sampling in conjunction with a special pulse-shaping and timing function fulfills all the objectives for timing recovery in this application. It recovers a timing phase that has minimum precursor intersymbol interference, and makes possible the combination of decision feedback equalizer and echo canceler, reducing the convergence time and increasing the step size. The pulse-shaping function can be performed either in the transmitter by means of digital coding, or in the receiver by means of analog filtering. In the latter case, the transmitted pulse is compatible with more conventional approaches. The proposed partial-response line coding, a special form of AMI coding, is less susceptible to line impairments if detected as a two-level signal. Performance by analysis, simulation, and experimental measurements is reported on a variety of cable configurations, some including bridged taps. Analysis of jitter performance leads to design techniques for reducing the jitter magnitude.