Abstract
The nonuniform cantilever beam and Hertzian contact model have been widely used to derive the mesh stiffness of spur gear assuming that the contact surface is absolutely frictionless. However, studies have confirmed that machined surfaces are rough in microscale and can be simulated by the Weierstrass–Mandelbort function. In order to get a reasonable and precise mesh stiffness model, the M-B contact model and finite element method are combined to express the local contact stiffness Kh. Through the simulation and comparison, the analytical finite element method is proved to be consistent with the traditional models and introduces the roughness parameters of machined tooth surface into the meshing process. Furthermore, the results also show that it is advantageous to improve the total mesh stiffness by increasing the fractal dimension D and input torque T as well as decreasing the roughness parameter G. In this paper, a relationship is built between the total mesh stiffness of gear sets with tooth surface characters and input torque, which can be a guidance in the design of the tooth surface parameters and the choice of the processing method in the future.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: Proceedings of the Institution of Mechanical Engineers, Part E: Journal of Process Mechanical Engineering
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
