Abstract
Milling with the focused helium ion beam of a helium ion microscope is one of the most accurate ways to produce nano-structures such as plasmonic nanoantennas. In addition to good and immediate control of the dimensions, features in the sub-10 nm regime are achievable. Especially small gaps and sharp tips in this regime may lead to very high field enhancement under excitation. However, the milling rate of 30 keV helium ions is rather low, making it time-consuming to cut nano-structures out of a gold film. We present two processes to work around the low milling rate to obtain arrays of nano-structures with maximum precision within a reasonable time. These strategies can both be adapted to either poly-crystalline gold films or single-crystalline gold flakes. Using single crystals from a fabrication point of view enables even higher precision due to constant etch rates over the whole crystal as well as straight edges and vertical side-walls due to the uniform crystalline structure.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
