Abstract
By employing destabilization heat treatments (HT), it is possible to create microstructures possessing different fractions of carbides, martensite, and austenite, which lead to varying tribological responses in abrasion-resistant high-chromium white cast irons. In the current work, the destabilization temperature was kept constant at 980 °C, whereas the time was varied from 0 to 90 min. As a result, the microstructure of the 26 wt% Cr white cast iron had a mixture of M23C6 secondary carbides (SC), martensite, and a decrease in the amount of retained austenite (RA) with increasing destabilization holding time. The microstructures as well as their tribological characteristics were evaluated by combining confocal laser scanning microscopy, SEM, XRD, and EBSD, together with dry-sliding linear reciprocating wear tests. Results show that the volume fraction of SC were statistically comparable in samples destabilized for 0 and 90 min, although the average size was almost two-fold in the latter. This had direct implications on the wear properties where a decrease of up to 50% in the wear rate of destabilized samples compared to the non-treated material was observed. Furthermore, the sample with the lowest increase in the matrix hardness (~ 20% higher than non-treated), showed the highest wear resistance. This was attributed to a favourable distribution of the RA (~ 10%) and SC volume fraction (~ 5%), in combination with the harder martensitic matrix. Finally, the results obtained from this study shed light on the ability to alter the HT parameters to tune the microstructure depending upon the application prerequisite.Graphical
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.