Abstract
The design of the tillage unit is presented, with new working bodies made in the form of a holder with rectilinear and oval parts, the rectilinear part is made in the form of a bar made at an acute angle to the horizontal surface and rigidly fixed on a rack with the possibility of dismantling. The lower part of the holder is shaped like an elongated ellipse, the upper oval part of which is a ripper, the lower-a slitter. The height of the ripper and the slitter is the same, on their butt line on the side of the toe, a groove is made for the pointed paw of the cultivator. On the back side of the paw, a groove is made for the holder, while the ratio of the length of the grooves of the paw and the holder is 1:3. The new design of the working body will improve the quality of tillage and water-air balance, increase crop yields and reduce fuel consumption.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: IOP Conference Series: Earth and Environmental Science
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
