Abstract
Titanium and its alloys are nowadays widely used in many sectors: in the medical field (orthopedic and dental ones), in the architectural field, in the chemical plants field and in aeronautic [1]. In this last field it is more and more used both for its contribution to make lightweight and time durable structures and for its compatibility with new materials, first of all Carbon Fiber Reinforced Plastics (CFRP). Cutting of titanium sheets is one of the primary requirements in the fabrication of most of the components. Laser cutting offers several advantages over conventional cutting methods. It includes narrow kerf width (minimum material lost), straight cut edges, low roughness of cut surfaces, minimum metallurgical and surface distortions, easy integration with computer numerically controlled (CNC) machines for cutting complex profiles and importantly non-contact nature of the process (suitable for cutting in hostile environments and in areas with limited access) [2]. However, due to very limited literature available on laser cutting of titanium, it is very difficult to predict the cut surface quality and optimum process parameters for laser cutting, especially when dross-free cuts are required. Laser cutting of titanium and titanium alloys needs to be carried out with an inert gas, this due to the high reactivity of the titanium with the oxygen at high temperatures [3]. However when the available power is limited, as in the present case, the use of a reactive gas (air) can help to achieve cutting speed value reasonable for industrial applications. The aim of this work is to study the cutting of Ti-6Al-4V rolled sheets 1 mm in thickness, by means of a 100 W fibre laser, (SPI-Red Power) working at wavelength = 1090 nm. The maximum cutting speed were measured in both CW and pulsed regime at different mean power and different duration. Furthermore, the kerf geometry and the heat affected zone (HAZ) were studied decreasing the cutting speed from the maximum to the 80 % of this values. The results obtained showed that both the power and the cutting speed influence the cutting kerf geometry and HAZ. In particular the synergy of power and speed, resulting roughly into the heat input, seems to rule the whole cutting process.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have