Abstract
Laves phase Ti-Mn-V type hydroden absorbing alloys are used for heat utilization systems such as refrigeration systems. Since the Ti-Mn-V alloys made by rapid solidification method show no segregation, the plateau becomes flat. However this effect is varied with the cooling rate. For this reason hydrogen absorption properties of hydrogend absorbing alloys made in various rapid solidification conditions were investigated. The measurements of pressure-composition isotherms, X-ray powder diffraction analyses and EPMA measurements were performed. As a result, it is found that the most suitable cooling rate exists for each alloy, and if cooling rate is too high, a peak width of X-ray powder diffraction broaden and the plateau becomes slope.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.