Abstract
AbstractThis article presents a new high‐efficiency three‐stage Doherty power amplifier (DPA) using a simple uneven power splitter. The proposed three‐way uneven power splitter, which was designed based on a multiway Wilkinson power divider, was applied to the three‐stage DPA. Also, the proposed structure is much simpler and uses fewer lumped components than the conventional one. Using the uneven input splitter, each individual amplifier in the DPA has an appropriate input power level. It results in a proper load modulation of the three‐stage Doherty amplifier. The proposed three‐stage DPA has been implemented for the E‐UTRA‐13 band of from 746 to 756 MHz. For the LTE‐frequency‐division duplexing release 9 downlink signal with a peak‐to‐average power ratio of 10 dB and a signal bandwidth of 5 MHz, a high power‐added efficiency of 42.3% and an adjacent channel leakage power ratio of −37 dBc at an offset of 2.7 MHz were experimentally achieved at an average output power of 30 dBm. © 2013 Wiley Periodicals, Inc. Microwave Opt Technol Lett 55:1405–1409, 2013; View this article online at wileyonlinelibrary.com. DOI 10.1002/mop.27581
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.