Abstract
An intricate three-dimensional porous medium was established to investigate the melting process of phase-change material (PCM) infiltrated in metal foams. Two kinds of metal foam with porosity gradient were designed to enhance the melting process. One of them was consist of three homogeneous porosity slices (85.9%–91.3%–95.8%), the other was with the porosity varying from 85.9% to 95.8% linearly. The evolution of the phase-change interface, velocity field distribution, and melting volume fraction of the composite PCM were studied numerically. The heat-transfer mechanism of the composite PCM was revealed by obtaining the evolution of the phase-change interface and the calculations of heat storage density and heat storage rate. The results indicated that the heat storage density increased with augmentation of the equivalent porosity. The metal foam with a porosity gradient increased the heat storage rate by enhancing the heat-transfer process at the corner of the bottom region. Finally, the ratio of the total heat-flux magnitude was always smaller than 1, which indicated that the heat conduction dominated the entire heat-transfer process.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.