Abstract
The aim of this in-silico study was to compare stress distributions in implants and zirconia frameworks of mandibular and maxillary implant-supported crowns. For comparison, vertical and oblique loading forces were used. Three-dimensional finite-element implant models of a mandibular section of bone (D2) and a maxillary section of bone (D4) with missing second molars and their zirconium-based superstructures were used. Zimmer dental implants of 13 mm in length and 4.7 mm in diameter were modelled. A load of 200 N was applied toward vertical and oblique (30° to the vertical) directions. Maximum and minimum von Mises stress values of the implants and the zirconia framework were calculated. The highest stress value was concentrated in the zirconia framework of the maxillary implant-supported model with the oblique loading force (301.17 MPa). The lowest stress value was concentrated in the mandibular implant-supported model. And the stress values in the maxilla were higher than in the mandible. The maxilla (D4) showed higher stress values than in the mandible (D2), because the trabecular bone is weaker and less resistant to deformation than the cortical bone. Stress values with oblique loading forces were higher than with vertical loading forces. Because of the high Young's modulus of zirconia (low elastic properties), zirconia frameworks showed higher stress values than the implants.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
