Abstract
Objective: To compare the biomechanical characteristics of four-implants mandibular overdentures supported by Locator attachment or bar-clip attachment under different mechanical loads using three-dimensional finite element analysis method. Methods: Two different models of four-implants supported mandibular overdentures using Locator attachment and bar-clip attachment (hereinafter called Locator model and bar-clip model) were established. Each model was subjected to five different mechanical loading conditions: 100 N vertical loading in central incisor (vertical load of incisor), 100 N vertical loading or oblique loading in canine (vertical or oblique loads of canines), 100 N vertical or oblique loading in mandibular first molar (vertical or oblique loads of mandibular first molar). The stress distributions in implants, peri-implant bone and mucosa were recorded under the above five conditions to evaluate the effects of different attachments on the biomechanical properties of implant-supported mandibular overdentures. Results: Regardless of loading conditions and types of attachments, the stress concentration in implants were located at the neck of implants, and the stress concentration in peri-implant bone was located in the cortical bone. The stress values in mucosa were always much smaller than those in implants and cortical bone. Regardless of loading positions (on canine or on mandibular first molar), the maximum stress at the bone interface around the implant under lateral loading was much higher than that under vertical loading. Under various loading conditions, the stress in implants and cortical bone of the Locator model (the highest von Mise stress value was respectively 79.5 and 22.3 MPa) were lower than that of bar-clip model (the highest von Mise stress value was 110.3 and 28.7 MPa respectively) while the maximum compressive stress in mucosa (0.198 MPa) in Locator model was slightly higher than that in the bar-clip model (0.137 MPa). Conclusions: In clinical practice, the lateral force applied to the implant-retained overdenture should be minimized to avoid complications caused by pathological loads. Under the same loading condition, the stress distributions in overdenture using Locator attachment are more dispersed, which is more conducive to long-term stability of implants.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
More From: Zhonghua kou qiang yi xue za zhi = Zhonghua kouqiang yixue zazhi = Chinese journal of stomatology
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.