Three-dimensional analysis of upper airway morphology in skeletal Class III patients with and without mandibular asymmetry.

Abstract

To compare the three-dimensional (3D) morphology of the upper airway in skeletal Class III patients with and without mandibular asymmetry and to investigate the possible underlying correlations between the morphology of the upper airway and mandibular deviation. Cone-beam computed tomography images of 54 subjects with skeletal Class III malocclusion (ANB angle ≤ 0.4°, Wits ≤ -5.5°) were taken and 3D upper airway models were reconstructed using Dolphin 3D software. According to the distance (d) from symphysis menti to the sagittal plane, all subjects were divided into a symmetry group (d ≤ 2 mm) and an asymmetry group (d ≥ 4 mm). Based on the severity of mandibular deviation, the asymmetry group was divided into subgroup I (4 mm ≤d <10 mm) and subgroup II (d ≥ 10 mm). Cross-sectional linear distances, areas, and volumetric variables of the upper airway were measured in the 3D airway model. Width of the inferior limit of the glossopharynx (P3W), cross-sectional area of the anterior limit of the nasal airway (P5S), and height of the glossopharynx (GPH) in the asymmetry group were significantly larger than in the symmetry group. As for subjects with severe mandibular deviation in subgroup II (d ≥ 10 mm), volume of the glossopharynx (GPV), total volume of the pharynx (TPV), length of the inferior limit of the velopharynx (P2L), and ratio of length to width of the inferior limit of the velopharynx (P2L/P2W) showed significantly negative correlations with mandibular deviation (r > 0.7, P < .05). In Class III subjects with severe mandibular asymmetry, the pharyngeal airway showed a tendency toward constriction and presented a more elliptical shape as mandibular deviation became more severe (P < .01).