Abstract

Three thousand successive disruptive strength tests are herewith shown. These were made in six groups with 500 tests in each group under constant conditions of test. Three groups of tests were taken of standard insulating oil with three different shapes of the electrostatic field; small sphere gap, large sphere gap, and sphere-needle gap. One group of tests was made with commercial and another with chemically pure benzol. The last group was made with air as a dielectric. A brief review of results and conclusions follows. In measuring the voltage by a single sphere gap, set in air with reasonable care, the maximum error of test does not exceed 4 per cent and the average error is 1 per cent. In the average of six successive tests the maximum error decreases from 4 per cent to 2.9 per cent and the average error decreases from 1 per cent to 0.6 of 1 per cent. In contrast to air, the behavior of oil is very erratic. Successive observations of its disruptive voltage, made under most carefully controlled conditions, differed by a percentage many times greater than the accuracy of the test,-the minimum value was as low as 49 per cent of the maximum. This inconstancy of the disruptive strength of oil appears inherent to the material. Little of the variation is dependent on the shape and size of the electrostatic field. Much of the variation is due probably to the complex chemical and physical nature of the oil.

Full Text
Paper version not known

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.