Abstract
A three-stage sequential extraction procedure, following a protocol proposed by a European working group coordinated and supported by the Community Bureau of Reference (BCR), has been applied to two river sediments from an industrial region of East Catalonia, Spain. The extractant solutions were: Step One, acetic acid (0.11 mol l −1); Step Two, hydroxylammonium chloride (0.1 mol l −1, pH 2); Step Three, hydrogen peroxide (8.8 mol l −1) oxidation followed by extraction with ammonium acetate (1 mol l −1, pH 2). The six elements determined in the extracts were Cd, Cr, Cu, Ni, Pb and Zn. Analysis of the extracts was carried out by flame atomic absorption spectrometry (FAAS). There were slight differences in analyte sensitivity between calibrants prepared in the extractant matrices and acidified aqueous calibrants. No significant interferences were found except for Cr in the acetic acid and hydroxylammonium chloride extracts, which required determination by the standard additions method. The other elements (plus all the elements in the ammonium acetate extracts) were determined by direct calibration against calibrant solutions prepared in the same matrices as the samples.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
