Three-dimensional printed cast assisted screw fixation of calcaneal fractures: a prospective study

Abstract

BackgroundTreatment of displaced intra-articular calcaneal fractures (DIACFs) with percutaneous screw fixation remains defective in some aspects. A novel three-dimensional (3D) printed cast was devised to assist screw placement. This study assessed the radiological and functional outcomes of 3D-printed cast assisted screw fixation for patients with DIACFs.MethodsPatients with unilateral Sanders type II or III DIACFs admitted to a single-centre hospital underwent either 3D-printed cast assisted screw fixation (3D group) or minimally invasive plate fixation (control group) from September 2020 to November 2022. All patients were assessed at one, two, three, and six months of follow-up. Comparison between groups was conducted in operative duration, fluoroscopic times, radiographic measurements of the calcaneus, and the American Orthopaedic Foot and Ankle Society (AOFAS) Ankle-Hindfoot Score.ResultsA total of 32 patients were enrolled (19 in the 3D group versus 13 in the control group). Significant differences were detected between the 3D group and control group in operative duration (53.63±8.95 min, 95.08±8.31 min, P <0.001), fluoroscopic times (7.37±1.21, 16.85±1.57, P <0.001). At a follow-up of six months, the 3D group showed better restoration than the control group in calcaneal width, height, Bohler angle, and AOFAS Ankle-Hindfoot scores (all P <0.001). No significant differences were shown in calcaneal length and Gissane angle (P >0.05). No wound-related complications occurred in either group.ConclusionThe 3D-printed cast assisted screw fixation has shown superiority over minimally invasive plate fixation in the operative duration, fluoroscopic exposure, morphological restoration of the calcaneus, and functional outcomes in the treatment of DIACFs.