Abstract

The performance of high shear airblast fuel injectors for advanced gas turbine combustors is highly dependent on the design of the swirl vanes. The vanes may be of the straight or curved type. Curved vanes usually exhibit lower losses but straight vanes are also used due to lower cost and ease of manufacture. These type of vanes often operate under highly stalled conditions with high total pressure loss and a highly non-uniform exit velocity profile. This can produce poor fuel atomization with a non-uniform combustor fuel distribution resulting in lowered combustor efficiency and increased pollutant emissions. Constant turning curved vanes can also be easily manufactured. Properly designed vanes result in a greatly reduced total pressure loss. The exit velocity distribution is more uniform and higher in magnitude resulting in improved fuel atomization and distribution in the combustor. The present study compares standard helical flat vane performance with a low loss curved vane designed by the author for idle, takeoff and cruise conditions. The results from a three dimensional viscous numerical flow simulation show the curved swirl vane to be clearly superior to the standard flat helical swirl vane. The curved vane has a much lower total pressure loss with a more uniform exit velocity profile. This will result in improved combustor and engine performance and reduced pollutant emissions.

Full Text
Published version (Free)

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call