Three-dimensional microstructure analysis of a polymer electrolyte membrane water electrolyzer anode

Abstract

The anode catalyst layer of a PEM water electrolyzer is reconstructed using a combination of FIB-SEM tomography and ionomer modeling. The pore space is infiltrated with silicone, enabling good discrimination between pores and IrRuOx catalyst material, while the ionomer cannot be imaged. The reconstructed volume of 29 μm × 24 μm x 7 μm contains catalyst particles with a median size of 0.5 μm and has a porosity of 55%. By modeling different ionomer contents inside the pore space, the impact on microstructural and transport parameters is investigated. At an ionomer content of 40–50% of the pore volume, all transport parameters are in a reasonable range, confirming experimental results from literature. At an ionomer content of 48% the catalyst layer has a porosity of 29%, a median pore size of 0.94 μm, a permeability of the pore space of 1.8mD and a mean ionomer film thickness of 0.4μm. The tortuosities of the ionomer and the pore space are calculated to 3.5 and 6.7 at the corresponding phase fractions of 26% and 29% respectively. The electrochemically active surface area estimated from the tomography (1.0m2g−1) is considerably lower than literature values, indicating a roughness below FIB-SEM resolution.