Three-Dimensional Changes of Alveolar Ridges and Nasolabial Structures Following a Digital Nasoalveolar Molding Therapy With a Novel Nasal Stent Activation Protocol

Abstract

Digital orthodontics has been integrated into NasoAlveolar Molding (NAM) therapy to overcome challenges in the conventional NAM method. This study introduced an individualized Digital NAM (iDNAM) and evaluated the changes in the alveolar ridges and nasolabial morphology after iDNAM treatment. Prospective data were collected from 15 infants with complete unilateral cleft lip and palate who underwent iDNAM therapy. An intraoral-and-nasolabial scan was used to create a virtual setup model and plate generation. A total of 2 plates were required under the iDNAM treatment protocol. The first iDNAM plate has a specific interior and exterior design to allow continuous force application with minimal plate adjustment. After an intermediate scan, a nasal stent was meticulously incorporated into the second plate for nasal molding. To activate the nasal stent, a silicone molding extension was used instead of manually adding acrylic. The alveolar cleft gap was significantly reduced by 7.48 ± 2.06 mm. On the cleft side, statistically significant increases occurred in nostril height, columellar length, and nasal base–columellar angle (2.08 ± 0.63 mm, 2.58 ± 0.28 mm, and 22.29 ± 0.88 degrees, respectively). By using 2 serial plates, iDNAM improved the alveolar cleft gap and the nasal morphology in complete unilateral cleft lip and palate. An addition of a nasal extension to the second iDNAM plate presents a challenge as accurate positioning is required for appropriate activation force. The iDNAM plate design and nasal activation protocol reduce the need for chairside adjustment and the number of appointments.