Abstract
Magnetically levitated permanent magnet planar motor is a new-generation motion device in modern precision industry, and the design of advanced motion controller has always been a main concern in the research and development of magnetically levitated permanent magnet planar motor. Due to the decrease in electromagnetic force caused by the deflection of the mover or the sharp decrease in magnetic flux density with height, it is very difficult to realize accurate positioning control of 3 degrees of freedom. In this article, an active disturbance rejection control scheme is adopted. The extended state observer is used to estimate the comprehensive disturbance and motion state in real time. Then, according to the value estimated by the extended state observer, the active disturbance rejection control motion controller can compensate the electromagnetic force in time to achieve good anti-jamming performance. Simulation and experimental results demonstrate that the adopted active disturbance rejection control scheme has good dynamic performance and uncertain disturbance robustness.
Highlights
The permanent magnet planar (PMP) motor has become one of the best performing mechanisms of the new-generation lithography machine due to its structural diversity, larger thrust density, favorable lowspeed stability, and other excellent properties.[1]
For the magnetically levitated permanent magnet planar (MLPMP) motor, if the uncertain disturbance caused by the mover deflecting through small angles is considered, and based on equations (3) and (7), the mechanical thrust balance equation describing the x-axial horizontal motion can be expressed as follows ðm + DmÞS€x + hx = fx fx = KxyeÀptznc Imx cos (Bu) + d ð8Þ
In order to verify the effectiveness of active disturbance rejection control (ADRC), an ADRC system for MLPMP motor is built and simulated in the MATLAB/Simulink environment
Summary
The permanent magnet planar (PMP) motor has become one of the best performing mechanisms of the new-generation lithography machine due to its structural diversity, larger thrust density, favorable lowspeed stability, and other excellent properties.[1] Traditional two-dimensional (2D) plane positioning device is generally composed of two sets of linear motion conversion structures and driven by two rotating electric motors. It is difficult to achieve higher level positioning accuracy owing to the linear motion conversion mechanism of friction, backlash, and deformation. Air bearing positioning platform can eliminate the friction, its structure is complex and the support stiffness is small, which result in lower bearing capacity and poor ability to resist shock.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.