Thin-Film Nb/Polyimide Superconducting Stripline Flexible Cables

Abstract

We present recent work on design, fabrication, and characterization of thin-film, flexible superconducting stripline cables. Fabrication details, dc, and microwave performance (up to 14 GHz) of cables with Al/Nb/Al conductors and polyimide (PI) dielectric are discussed. Thin Al was used as a barrier layer between Nb and polyimide to protect the Nb superconductivity during subsequent PI curing steps, which were performed at a reduced temperature. The dc performance, including critical transition temperature and critical current, of the stripline transmission lines is presented. We observed T <sub xmlns:mml="http://www.w3.org/1998/Math/MathML" xmlns:xlink="http://www.w3.org/1999/xlink">c</sub> values of ~8.8 and ~8.6 K for signal traces and ground planes, respectively. Microwave characterization, including cross-talk, was performed on stripline transmission lines and resonators. We observed reasonable impedance match (S <sub xmlns:mml="http://www.w3.org/1998/Math/MathML" xmlns:xlink="http://www.w3.org/1999/xlink">11</sub> better than -15 dB), low insertion loss (S <sub xmlns:mml="http://www.w3.org/1998/Math/MathML" xmlns:xlink="http://www.w3.org/1999/xlink">21</sub> better than 0.04 dB/cm) and cross-talk below -60 dB for stripline transmission lines measured up to 10 GHz at 4.2 K. Furthermore, similarly fabricated stripline resonators exhibited quality factors ~7 000 at 10 GHz and 1.2 K for stripline resonators. The results of these experiments provide insight into material stack-ups for robust, multi-layer superconducting flexible cables that can find use in future cryogenic electronics systems.