Thin-film lithium batteries with 0.3–30 μm thick LiCoO2 films fabricated by high-rate pulsed laser deposition

Abstract

High-rate pulsed laser deposition was applied to the preparation of thick LiCoO2 cathode films, which were then used in the fabrication of thin-film batteries. The deposition rate of the LiCoO2 films was 2–3 μm/h. The thin-film batteries showed an increase in capacity up to 470 μAh/cm2 with increasing cathode film thickness. The rate dependence of discharge capacity was analyzed using a diffusion model in which the chemical diffusion coefficient of lithium in the cathode determines the dynamic capacity. For the initial stage of discharge, the chemical diffusion coefficient was estimated to be 10−10 cm2/s. Conversely, the chemical diffusion coefficient decreases to ~10−12 cm2/s at the end of discharge. From the diffusion model, the available capacity was estimated as a function of cathode thickness. Crack formation inside the LiCoO2 film is also suggested as a cause of capacity limitation.