Abstract

We have built and tested a thin-film high temperature superconducting (HTS) surface coil for MRI at 0.064T. When placed as close as possible to a conductive sample, the 6.7-cm outer diameter HTS coil had a measured signal-to-noise ratio (SNR) 1.8 times higher than a room temperature copper coil of similar size and location. Our results predict that in some cases, SNR gains of about a factor of 2 can be attained in low-field MRI systems by substituting HTS surface coils for copper coils.

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.