Abstract
Techniques to determine the thickness of thin (30–200 Å) anodic oxide films on p-GaAs (100) are reported. The layers were grown potentiostatically in 0.3 M NH4H2PO4 (pH 4.4) solution. By lithographic techniques, several series of squares were etched into the oxide and the step height was measured using both atomic force microscopy (AFM) and a stylus surface profiler (Dektak). Secondary ion mass spectrometry (SIMS) profiles of samples prior to and after the photolithographic treatment show that neither the thickness nor composition of the layers are affected by the treatment. The thickness values obtained in the investigated range show standard deviations better than ±9 Å (AFM) and ±22 Å (Dektak) and correlate well in a linear relation to SIMS sputter times to the interface.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
