Thickness Effect of 2195 Al-Li Alloy Friction Stir Weld Fracture Toughness.

Abstract

For damage tolerance design in engineering components, the fracture toughness value, KIC, of the material is essential. However, obtaining specimens of sufficient thickness from stir friction welded plates is challenging, and often, the experimental test values do not meet the necessary criteria, preventing the experimental fracture toughness, Kq, from being recognized as plane strain fracture toughness KIC. The fracture toughness Kq of 2195 Al-Li alloy welding seams with different thicknesses was measured on the forward and backward sides. Microstructure characterization was conducted by scanning electron microscope (SEM). The results indicated minimal significant differences in grain size between the advancing and retreating sides of the weld nugget zone. In specimens of the same thickness, fracture toughness measurements along the normal direction of the joint cross-section showed a high similarity between the advancing and retreating sides of the weld nugget zone. Utilizing the quantitative relationships between fracture toughness and sample thickness derived from both the fracture K and G criteria, it is possible to predict the fracture toughness of thick plates using thin plates. This study employs these relationships to calculate the fracture toughness KIC of 2195 aluminum-lithium alloy friction stir welds. The KIC values obtained are 41.65 MPa·m1/2 from the fracture K criterion and 43.54 MPa·m1/2 from the fracture G criterion.