Abstract
PurposeCompression rings are the main sources of frictional losses in internal combustion engines. The present paper aims to present a thermo-mixed hydrodynamic analysis for coated top compression rings. To understand the coating effects, the main tribological parameters are investigated into a ring-cylinder conjunction in a motorbike engine. Furthermore, flow simulations have been carried out on how different worn profiles on the cylinder inner liner affects friction, lubricant film and localized contact deformation of the coated compression rings.Design/methodology/approachIn this paper, the basic geometrical dimensions of the top compression ring-cylinder system are obtained from a real motorbike engine. A 2D axisymmetric CFD/FLOTRAN model is created for coated compression rings. Flow simulations are performed by solving the Navier-Stokes and the energy equations. The load capacity of the asperities is also taken into account by Greenwood and Tripp contact model. Realistic boundary conditions are imposed to simulate the in-plane ring motion. The simulation model is validated with analytical and experimental data from the literature. Under thermal considerations, the contribution of worn cylinder profiles in conjunction with different coated compression rings is presented.FindingsThis research shows that because of thermal effects, the boundary friction is higher at reversals and the viscous friction is lower because of reduced oil viscosity. As regards to the isothermal case, the viscous friction is greater because of a higher lubricant viscosity. In the case of chromium-plated ring, boundary friction was 16 per cent lower than a grey cast iron ring taking into account thermal effects. Regarding the localized contact deformation, the coated compression rings showed lower values under different worn cylinder shapes. In particular, hard wear-resistant (Ni-Cr-Mo) coating showed the slighter local deformation. Therefore, the worn cylinder profiles promote boundary/mixed lubrication regime, whereas the lobed profile of cylinder inner liner becomes more wavy.Originality/valueThe solution of the thermo-mixed lubrication model, concerning the piston ring and worn cylinder tribo pair by taking into account the coating of the top compression ring.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.