Abstract
Thermo-mechanical fatigue (TMF) behavior in a <0 0 1> oriented nickel-based single crystal superalloy was investigated under different cycles of strain and temperature. Fracture surface and microstructural evolution were observed by scanning electron microscopy (SEM) and transmission electron microscopy (TEM) respectively. It was found that the fatigue lives under in-phase (IP) TMF were longer than those of out-of-phase (OP) TMF, and the maximum tensile stress level was concluded to be the lifetime-limiting factor. Compared to isothermal low-cycle fatigue (LCF) lives obtained under the maximum temperature 900 °C, thermo-mechanical fatigue lifetime was much shorter. This result indicates that varying temperature superimposed mechanical strain greatly reduces the fatigue lifetime of superalloys. Based on observation of fracture surface and microstructure evolution, it was concluded that creep is the dominant damage mechanism under IP-TMF condition and oxidation causes shorter lifetime for OP-TMF tests. The similarities and differences in the changes of γ′ morphology during in-phase (IP) and out-of-phase (OP) TMF tests were also discussed.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
