Abstract
The effects of mechanical deformation and subsequent annealing on the thermoelectric properties and microstructure have been investigated for p-type (Bi0.25Sb0.75)2Te3 alloys prepared by melting followed by quenching. The mechanically deformed pellets were prepared by repetition of cold-pressing of quenched samples at room temperature. Cold-pressed pellets were then annealed at 300°C in vacuum, and the thermoelectric properties and microstructure were traced through the course of the heat treatment. For the heavily deformed samples, the Seebeck coefficient rapidly increased at the very early stage of annealing and did not change as the annealing time increased, due to recrystallization of a new δ-phase which equilibrated at the annealing temperature of 300°C (δ300-phase). At the initial stage of annealing (recovery stage), the electrical resistivity sharply increased, probably due to the interaction of antistructural defects with vacancies produced during the cold-pressing treatment. However, for the lightly deformed samples, recrystallization occurred only at some portion of the grain boundaries, and the newly generated δ300-phase slowly replaced the original, as-solidified δingot-phase.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
