Abstract
Calorimetry offers a direct measurement of thermodynamic properties of materials, including information on the energetics of phase transitions. Many materials can only be prepared in thin film or small crystal (submilligram) form, negating the use of traditional bulk techniques. The use of micromachined, membrane-based calorimeters for submilligram bulk samples is detailed here. Numerical simulations of the heat flow for this use have been performed. These simulations describe the limits to which this calorimetric technique can be applied to the realm of small crystals (1-1000 microg). Experimental results confirm the feasibility of this application over a temperature range from 2 to 300 K. Limits on sample thermal conductivity as it relates to the application of the lumped and distributed tau 2 models are explored. For a typical sample size, the simulations yield 2.5% absolute accuracy for the heat capacity of a sample with thermal conductivity as low as 2 x 10(-5) W/cm K at 20 K, assuming a strong thermal link to the device. Silver paint is used to attach (both thermally and physically) the small samples; its heat capacity and reproducibility are discussed. Measurements taken of a submilligram single crystal of cobalt oxide (CoO) compare favorably to the results of a bulk calorimetric technique on a larger sample.
Paper version not known (
Free)
Published Version
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
