Thermodynamic aspects of cell spreading on solid substrata

Abstract

To verify the validity of thermodynamic approaches to the prediction of cellular behavior, cell spreading of three different cell types on solid substrata was determined in vitro. Solid substrata as well as cell types were selected on the basis of their surface free energies, calculated from contact angle measurements. The surface free energies of the solid substrata ranged from 18-116 erg cm-2. To measure contact angles on cells, a technique was developed in which a multilayer of cells was deposited on a filter and air dried. Cell surface free energies ranged from 60 erg cm-2 for fibroblasts, and 57 for smooth muscle cells, to 91 for HeLa epithelial cells. After adsorption of serum proteins, cell surface free energies of all three cell types converged to approx 74 erg cm-2. The spreading of these cell types from RPMI 1640 medium on the various solid substrata showed that both in the presence and in the absence of serum proteins in the medium, cells spread poorly on low energy substrata (Ys less than 50 erg cm-2), whereas good cell spreading was observed on the higher energy substrata. Calculations of the interfacial free energy of adhesion (delta Fadh) show that delta Fadh decreases with increasing Ys, and equals zero around 45 erg cm-2 for all three cell types in the presence of serum proteins and for HeLa epithelium cells in the absence of serum proteins. This explains the spreading of these cells on the various substrata upon a thermodynamic basis. The results clearly show that substratum surface free energy has a predictive value with respect to cell spreading in vitro, both in the presence and absence of serum proteins. It is noted, however, that interfacial thermodynamics fail to explain the behavior of fibroblasts and smooth muscle cells in the absence of serum proteins, most likely because of the relatively high surface charges of these two cell types.