Thermally stable bromobutyl rubber with a high crosslinking density based on a 4,4′‐bismaleimidodiphenylmethane curing agent

Abstract

ABSTRACTThe development of thermally stable bromobutyl rubbers has been a challenge in rubber chemistry and engineering. In this circumstance, 4,4′‐bismaleimidodiphenylmethane (BMI) was newly applied as a novel crosslinking agent for thermally stable brominated isobutylene–isoprene rubber (BIIR) with a high crosslinking density. With oscillating disk rheometry and differential scanning calorimetry, the curing characteristics of BIIR were systematically investigated with respect to the content of BMI. We found that BMI alone could crosslink BIIR at higher temperature, and a corresponding possible chemical reaction mechanism was proposed. With the introduction of zinc oxide, the curing reaction of BIIR with BMI was significantly accelerated, and the resulting vulcanizate provided a higher state of curing with excellent overcure reversion stability even at a temperature of 190 °C for 2 h. The content of the dicumyl peroxide (DCP) reaction accelerator was also optimized to be BMI/DCP = 1:0.05 on the basis of considerations of the curing rate, scorch safety, maximum rheometric torque, and reversion resistance at 160 °C. Compared with the conventional sulfur‐cured BIIR, the BMI‐cured BIIR exhibited a higher crosslinking density with a superior low compression set property at elevated temperatures and an excellent thermal stability. © 2016 Wiley Periodicals, Inc. J. Appl. Polym. Sci. 2016, 133, 44092.