Thermal performance of three concentrating collectors with bifacial photovoltaic cells part I – Experimental and computational fluid dynamics study

Abstract

Bifacial photovoltaic cells can produce electricity from incoming solar radiation on both sides. These cells have a strong potential to reduce electricity generation costs and may play an important role in the energy system of the future. However, today, these cells are mostly deployed with one side receiving only ground reflection, which leads to a profound sub-optimal utilization of one of the sides of the bifacial cells. Concentration allows a better usage of the potential of bifacial cells, which can lead to a lower cost per kWh. However, concentration also adds complexity due to the higher temperatures reached which add the requirement of cooling in order to achieve higher outputs. This way, this paper focuses on the effectiveness of forced air circulation methods by comparing the thermal performance of three specific concentrating bi-facial collector designs. This paper developed a computational model, using ANSYS Fluent intending to assess the thermal performance of a covered concentrating collector with bifacial Photovoltaic (PV) cells. These results have then been validated by outdoor measurements. Results show that even a simple natural ventilation mechanism such as removing the side gable can effectively reduce the receiver temperature, thus resulting in favourable cell operation conditions when compared to the case of an airtight collector. Therefore, compared with a standard model, a decrease of 13.5% on the cell operating temperature was reported when the side gables are removed. However, when forced ventilation is apllied a 22.8% reduction on temperature is found compared to the standard air-tight model. The validated CFD model has proven to be a useful and robust tool for the thermal analysis of solar concentrating systems.