Abstract
Single-walled carbon nanotube–water nanofluids were tested in a 1–5 TEMA E shell and coil heat exchanger. Cold nanofluid, flowing inside the coil, was heated by hot water flowing in the shell side. Volumetric fraction of nanoparticles, inlet temperature of nanofluid, and mass flow rate of nanofluids ranged from 0 to 0.21%, 2.3 to 23.4 °C, and 40 to 90 g/s, respectively. For a given Reynolds number, at the coil side, pure base fluid (φ = 0%) performed better than low-concentration nanofluid samples (φ = 0.035% and 0.053%) and was nearly equivalent to the nanofluid of highest concentration, φ = 0.21%. The thermal conductivity enhancement factor of the nanofluid ranged from 0 to 0.2 and to 0.45, at inlet temperatures of 30 °C and 50 °C, respectively. It is believed to work in favor of a better performance of the nanofluid samples. On the other hand, the unusual (literature-wise) low temperature of the nanofluid further amplified the enhancement of the nanofluid viscosity, with a reduction effect on the Reynolds number. Besides, other thermal resistances of the heat exchanger work toward an attenuation of the enhancement effect that nanoparticles may have in the heat exchanger performance.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
More From: Journal of the Brazilian Society of Mechanical Sciences and Engineering
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.