Abstract
Thermoplastic tape placement opens the possibility of a fully automated composite production. The resulting quality is highly dependent on the thermal history during consolidation. This article focuses on the thermal modelling of a tape placement system employing a near-infrared laser. A nonlinear two-dimensional finite element model is presented for a carbon fibre reinforced thermoplastic (AS4/PEEK) composite placement process using a conformable roller. The relative influence of roller geometry, roller temperature and thermal contact resistance was studied. Temperature measurements were performed using thermocouples welded to the substrate. The model predictions show good correlation in terms of timing of the irradiation, shadow and consolidation regions. The roller temperature was found to have the most significant impact on the bond line temperature distribution.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
