Abstract
In the present study both experimental measurements and calculation models have been used to investigate the practical performance of reflective foils in air filled floor cavities. The laboratory measurements were performed in a pivotal guarded hot-box. Both heat flow down through the floor area and the temperature distribution in the cavities were measured. The number of reflective foils and the amount of edge insulation at the edge beams has been varied as well as the environmental temperature conditions. Measured and calculated results show good agreement for most of the tested timber floor variants.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
