Thermal Effects on Shear Fracturing and Injectivity During CO2 Storage

Abstract

With almost two hundred coal burning power plants in Ohio River valley, this region is considered important for evaluation of CO2 storage potential. In a CO2 storage project, the temperature of the injected CO2 is usually considerably lower than the formation temperature. The heat transfer between the injected fluid and rock has to be investigated in order to test the viability of the target formation to act as an effective storage unit and to optimize the storage process. In our previous work we have introduced the controversial idea of injecting CO2 for storage at fracturing conditions in order to improve injectivity and economics. Here we examine the thermal aspects of such process in a setting typical for Ohio River Valley target formation. A coupled flow, geomechanical and heat transfer model for the potential injection zone and surrounding formations has been developed. All the modeling focuses on a single well performance and considers induced fracturing for both isothermal and thermal injection conditions. The induced thermal effects of CO2 injection on stresses, and fracture pressure, and propagation are investigated. Possibility of shear failure in the caprock resulting from heat transfer between reservoir and the overburden layers is also examined. In the thermal case, the total minimum stress at the wellbore decreases with time and falls below the injection pressure quite early during injection. Therefore, fracturing occurs at considerably lower pressure, when thermal effects are present. The coupled thermal and dynamic fracture model shows that these effects could increase the speed of fracture propa‐ gation in the storage layer depending on the injection rate. These phenomena are dependent primarily on the difference between the injection and reservoir temperature. © 2013 Goodarzi et al.; licensee InTech. This is an open access article distributed under the terms of the Creative Commons Attribution License (http://creativecommons.org/licenses/by/3.0), which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited. Our results show that shortly after injection, the induced expansion in caprock lead to slight increase of total stresses (poroelasticity) which will reduce the chance of shear failure. However as soon as total minimum stress in the caprock decreases due to thermal diffusion between the reservoir and caprock, thermoelasticity dominates and the chance of shear failure increases in the caprock. Incorporation of thermal effects in modeling of CO2 injection is significant for understanding the dynamics of induced fracturing in storage operations. Our work shows that the injection capacity with cold CO2 injection could be significantly lower than expected, and it may be impractical to avoid induced fracture development. In risk assessment studies inclusion of the thermal effects will help prevent the unexpected leakage in storage projects.