Abstract
AbstractThe thermal conductivity of a rubber compound is studied as a function of its state of curing. The device is presented and the calculations in order to obtain samples with controlled and homogeneous vulcanization rates are performed. The hot disk technique is used to measure the thermal conductivity of the rubber. This transient, plane‐source and non‐destructive method allows rapid and accurate measurement of the thermal conductivity based on the measurement of the electrical resistance of a plane sensor placed between two identical samples. The obtained results show that the thermal conductivity may vary significantly as a function of vulcanization rate. The effect of this variation on the prediction of the reaction progress is discussed.magnified image
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
