Abstract
Abstract In this study, DSC experiments were used to elaborate an annealing protocol for injection molded very high molecular weight (VHMW) PLLA with two molecular masses, 320,000 g/mol and 700,000 g/mol. The initial material obtained from the injection molding process was found to be highly amorphous and not in thermodynamic equilibrium state, as distinct cold crystallization and enthalpy relaxation were observed in DSC data. Thermal annealing to 85 °C for 60 - 90 min under controlled conditions using a DSC device showed to be sufficient to stabilize the polymer and increase the crystallinity to up to 50 %. Annealing did not result in any signs of thermal decomposition. The elaborated thermal treatment has been transferred to manual annealing of large specimen geometries for subsequent DMA analysis.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
