Thermal and mechanical analysis of thermal break structure in balcony with basalt fiber reinforced polymer

Abstract

Thermal break structure is an effective design to reduce building energy consumption in balcony. The traditional stainless-steel bars or other FRP components reinforced thermal break structures can't enable both mechanical performance and thermal insulation concurrently because these materials are difficult to have low thermal conductivity and high mechanical properties at the same time. This paper proposes to use basalt fiber reinforced polymer (BFRP) to construct the thermal break structure due to the high load-bearing capacity and thermal insultation of BFRP. The thermal performance of the structure is systematically verified through three-dimensional simulation. Influence of thermal break widths, loading point positions, shear reinforcement forms and reinforcement types on the mechanical properties of the structure is investigated. The results show that BFRP can significantly reduce the linear heat transfer transmittance while ensuring structural mechanical properties. A larger thermal break width leads to the low load-bearing capacity of the structure. Lower BFRP compressive reinforcements need enough diameter to provide compressive strength and shear reinforcement forms can significantly increase the mechanical properties of the thermal break. Upper tensile reinforcements can be selected depending on the stiffness and insulation requirements in practical engineering. Based on experimental results, force transfer mechanism is analyzed and the rationality of the structural design is identified. The maximum length of the cantilever slab without shear reinforcement forms is approximately 2.94 m when meets the serviceability limit state. The results suggest that newly designed BFRP thermal break structure can effectively solve thermal bridge problems in balcony.