Thermal and hydraulic characteristics analysis of horizontal lead-bismuth reactor assembly based on sub-channel analysis code

Abstract

In this paper, the self-developed subchannel analysis program SACOS-PB was used to analyze the thermal hydraulic characteristics of 127 rods in horizontal lead-bismuth reactor under steady state and typical ocean transient conditions. The results of the steady-state analysis showed that the coolant flow and temperature of the vertical assembly were symmetrically distributed, the coolant flow of the horizontal assembly gradually increased along the gravity direction, the temperature rose first and then fell, and the peak coolant temperature of the cross-sectional channel was about 365 °C. Three typical ocean transient operating conditions, inclined, undulating and swing, were also carried out. The results showed that the maximum temperature of the coolant at the exit of the assembly increased with the increase of the transverse heeling angle and the decrease of the trim angle after the incline motion changes the gravity component. Under the undulating and swing conditions, the coolant hydrothermal parameters fluctuated periodically, and the parameter fluctuation period is 10s in line with the oceanic conditions. In the above transient conditions, the peak coolant temperature at the assembly outlet increases and exceeds 365 °C. Compared with the pitching motion on the Y-axis, the rolling and tumbling motion on the X-axis had a significant effect on the coolant flow rate and temperature distribution. The calculation results can provide support for the analysis study of the safety characteristics of lead-bismuth power units under marine conditions.