Thermal and cyclic performance of aluminum alloy composite phase change microcapsules for high-temperature thermal energy storage

Abstract

Al alloys are suitable for high-temperature applications such as solar thermal power generation and industrial heat utilization. However, addressing the challenges of high-temperature corrosion and material failure in Al alloys is of paramount importance. In practical industrial applications, there is a need to develop encapsulation techniques applicable to a wider range of Al alloy types and phase change temperature ranges, exploring the universality of the technology and the diversity of application scenarios. In this study, a dual encapsulation was conducted on binary and ternary Al alloys (including Al-Ni, Al-Mg, Al-Si-Mg, and Al-Mg-Zn). Aiming at thermal energy storage, four composite phase change microcapsules (CPCM) were successfully prepared and subjected to material characterization, thermal performance analysis, and thermal cyclic tests in air environments. After 2000 thermal cycles, no cracks were observed on the surface of the four CPCMs, and the microstructure remained intact. The components of the CPCMs maintained good chemical compatibility. Among the four types of CPCMs, the Al-Si-Mg CPCMs exhibited the best thermal cyclic stability, with a latent heat reduction rate of 19.5 % after 2000 cycles. The experimental results indicated that the dual encapsulation strategy was effective for various types of Al alloy PCMs, thereby expanding the application of Al alloys in high-temperature thermal storage. Furthermore, Al alloys with more regular morphology and lower active metal content exhibited better thermal performance and cyclic capability, making them more suitable candidates for high-temperature thermal storage applications.