Thermal analysis technology to utilize waste biomass and waste heat to produce high-quality combustible gas through simulations and experiments

Abstract

To ensure the proper utilization of waste biomass (WB) and high-temperature waste heat, this study proposes a new method for obtaining gaseous fuels by pyrolyzing WB and using waste heat in the converter vaporization cooling flue (CVCF). This study is theoretically based on the simulation software Factsage 6.1 and the release patterns of the gaseous products including CO, H2, CH4 and CO2 obtained from waste biomass, were studied at different temperatures and pressures. Thermogravimetric-mass spectrometer (TG-MS) was used to investigate the pyrolysis of WB at heating rates of 5, 10, 15, and 20 °C/min from room temperature to 1400 °C. Kinetics parameters were calculated by using the Flynn-Wall-Ozawa (FWO) and Kissinger-Akahira-Sunose (KAS) models. To investigate the effects of temperature, a settling furnace was also used to simulate CVCF. Thermal decomposition produced the primary gases namely CO, CH4, and H2. Pyrolysis had an average activation energy of 183.29 kJ/mol. As the temperature increased from 800 °C to 1200 °C, the CO content increased from 39.7 % to 48.9 % and the H2 content increased from 35 % to 45.1 %. As the temperature rose from 800 to 1200 °C, the lower heating value (LHV) increased from 11.38 to 12.05 MJ/Nm3. The findings primarily confirmed the feasibility of injecting biomass into the CVCF to generate gaseous fuels from waste heat.