Abstract
AbstractThis work encompasses the development of low‐viscosity cyclic oligomer underfill formulations that cure without heat evolution. Boron nitride, silica‐coated aluminum nitride, and alumina ceramic powders were used as fillers in cyclic butylene terephthalate oligomer melts. The melts were heated with a suitable catalyst to induce polymerization. The effects of the filler type and composition on the thermal and mechanical properties of the poly(butylene terephthalate)/filler composites were examined with differential scanning calorimetry, temperature‐modulated differential scanning calorimetry, thermogravimetric analysis, thermomechanical analysis, and dynamic mechanical analysis. Scanning electron microscopy was employed to elucidate the morphology of these composites. © 2005 Wiley Periodicals, Inc. J Appl Polym Sci 98: 1300–1307, 2005
Submitted Version (
Free)
Published Version
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
