Abstract
ABSTRACT The purpose of this study is to investigate the effect of the position of the solar collector absorber and stagnant air relative to the airflow path on the thermodynamic properties of traversing air and the overall thermal performance of the collector. A numerical model was developed and validated using five different absorber design positions. Numerical results are validated using experimental data obtained from Epinal (France). The model was subsequently used to parametrically study the influence of these absorber positions on the density, temperature, velocity variations of the airflow through the collector and the thermal efficiency of each case scenario. The study showed the importance of stagnant air in solar collector thermal performance. Also, it showed that when one absorber is used, it is better to locate the absorber on the top of the airflow path than below the airflow path. Sandwiching the airflow path between double absorbers with the upper absorbers having stagnant air between it and the plexiglass cover and the down absorber having stagnant air between it and the bottom of the collector can produce a thermal efficiency of 31% which is 2% higher than the closest case and 13% higher than the worst-case design.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
