Abstract

Much research is ongoing to find suitable alternate fuels in order to reduce the exhaust emission levels without deteriorating the basic performance characteristics of conventional spark-ignited (SI) engines. One of the methods to achieve the above problem is the use of alcohols as full supplement fuels to normal gasoline. At the same time, many related research studies have shown that the use of alcohols has a negative impact on some basic engine performance characteristics, e.g., brake power output, etc. On the other hand, spark timing is one of the critical engine operating parameters that significantly influences the combustion mechanism inside the combustion chamber of a SI engine. Therefore, the primary objective of the present work is to investigate the effect of spark timing on the performance and emissions characteristics of a conventional, four-stroke, SI engine running under three different fuel operating modes, viz. with conventional gasoline or ethanol or butanol. The specific investigation is conducted by using an in-house, comprehensive, two-zone phenomenological model. The predictive ability of the model is tested against pertinent experimental data and it is found that the computed results are in good agreement with the respective experimental ones. For all test cases examined herein, the results concern basic engine performance characteristics, i.e., cylinder pressure, power output, specific fuel consumption etc., as well as NO and CO emissions. The main objectives of the work were to record and evaluate the impact that spark timing has on the performance characteristics and emitted pollutants of a conventional SI engine, operating under either conventional gasoline or ethanol or butanol fuel operating modes. Moreover, it deals with the determination of an optimum combination between the type of fuel used and the spark timing, so that probable undesirable effects on engine performance characteristics would be avoided. By comparing this investigation results, it is revealed that the use of alcohols as a full substitute fuel of gasoline accompanied with an appropriate alteration of the spark timing, could be a promising solution to improving both the efficiency and environmental behavior of a light-duty, spark-ignited (SI) engine, without causing any harmful problems to the engine operational lifetime. The conclusions from the study may prove valuable for the application of this technological solution to existing conventional SI engines.

Highlights

  • The large increase in air pollution observed in recent decades is one of the most important problems in developed countries

  • An existing two-zone phenomenological model is used to examine the effect of spark timing on the performance and emissions of a light-duty, SI engine running under either gasoline or ethanol or butanol fuel operating modes

  • A good coincidence for both performance characteristics and pollutant emissions was observed between calculated and measured values, which correspond to the same engine operating point, i.e., 100% of full engine load and spark timing equal to 23 deg CA

Read more

Summary

Introduction

The large increase in air pollution observed in recent decades is one of the most important problems in developed countries. Exhaust emissions emitted by piston internal combustion engines play a very important role in this problem. In addition to changing the engine design, it is necessary to find technologies that will allow the use of alternative fuels (i.e., biofuels) in new or existing piston internal combustion engines. The use of alternative fuel in existing engines without requiring significant changes to the engine structure should be possible [1,2,3,4]. The rising fuel prices and the increased oil consumption along with the lack of sustainability of oil-based fuels have generated vivid interest in alternative, renewable sources of fuels for motor vehicles. Alcohol-based fuels are considered as very promising fuels, which could possibly replace fully the conventional liquid fuel (gasoline or diesel fuel) in reciprocating internal combustion engines [5,6,7]

Objectives
Results
Conclusion
Full Text
Published version (Free)

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call